Schwerer Zugkraftwagen 18t
Sd.Kfz.9 "FAMO"
Tamiya 1:35 Scale Kit No. 35239
Page 1 of 1
Where the plumbing goesThe gear linkages and brake line heading off the front just end at the rear side if the firewall as it's impossible
to have these link directly through the cab and engine compartment given the method of assembly, similarly some of the lines
from the forward firewall end there and don't join as one piece to the rear plumbing.
These areas can't be seen after assembly and you can pick up the and extend the plumbing on either side if you wish?
From the main compressor there are three air lines
1. Top Lead goes back to the rear compressed air tank junction.
4. Lower small connecting lead from compressor to line 5 with T connector.
5. Line from back of compressor along the right side of the chassis to the rear hull air connector.
Another view of the front compressor with lines 1, 4 and 5.
3. Line from the two lower air tanks to the rear junction.
2. Line to right side air tank.
Close up of front and rear compressor with lines as above, also note the connectors from the etched parts.
Air tank connectors.
Rear air line 5, note the etched connectors 6.
