Hull details
Interior sub assemlies
Engine bulkhead assembly
Interior floor assembly
Full interior with just the side wall items to be added
Comparison of Dragon (left) and Tamiya (right) glacis access hatch sizes.
The Tamiya hatch better represents those shown in images of the Ausf.C hatch which I have seen.
Lower hull front panel with correct curve of the plate
A couple of things to watch on the rear deck.
The rear grill (part A26) has to be located centrally in the opening with a gap either side
but the instructions don't tell you this.You also need to trim away the exposed parts of the inner lip
before fitting the grill as this shouldn't show in the opening.
Also the gap around the two engine bay doors is not large enough as these are not flush fitting like many
doors and the gap should be about twice the size than on the kit, referring to photos will fully illustrate this.