It consists on a single resin piece with a 4mm square "head" with the zimmerit pattern embossed, while the body of the piece is large enough to hold comfortably while using the tool.
The method would be to cover a small section of the target kit with a thin film of putty or two part resin (or whatever you prefer) and use the tool to stamp the pattern in.
While I haven't actually tried using this tool but it seems to be easy enough to get a good pattern on the target model with the tool head being small enough to get around tight detail on the kit.
A small instruction sheet is included with a guide to applying the putty and using the tool which should help out.
Should prove to be quite useful.
This and other figure sets are available direct from
Thanks to David from for the review sample.
Page created 5 April 2003