Meng Model
Pickup w/ZU-23-2
Meng Model 1:35 Scale Kit #VS-004
Page 4 of 6
backnext ZU-23-2 Gun assembly
Gun carriage parts
Meng Model
Assembled gun carriage views.
Meng Model
Round trunnions added to carriage, note these must be perfectly vertical and parallel to the carriage
as there is possibilities for these to be miss-aligned.
Also see the three alternate elevation cylinders depending on the degree of elevation required.
I used the shortest cylinder to allow the guns to elevate after assembly.

Meng Model
The guns and trunnion assembly added to the turntable.
Meng Model
The main sight and arm linkage are designed to be glued in place depending on your choice of elevation,
but these can easily be made workable to allow you to elevate the guns at any time.
1. Drill holes in the sight mountings as indicated (I used 0.5mm plastic rod for the pins)
2. Glue a short pin to the end of the sight arm to go into the hole drilled in its mounting (Part H12 not shown)
3. Fit the sights and sight arm together holding in place by the plastic rod pins to allow full movement.
Note: this is optional and you just glue the sight and arm together as per instructions if you
don't want to alter the gun elevation after assembly.

Meng Model
Main sight and sight arm fitted together with plastic rod pin prior to fitting to the gun mounting.
Meng Model
Rear sight mounting and ammo boxes added.
Meng Model
Main sight and sight arm fitted to the gun mounting.
Meng Model
Note how the sight moves with the gun elevation after the alterations as above.
Meng Model
Seats, wheel guards and other small details added to finish the gun assembly.
Meng Model
backnext



Back to Top