SKP Model
Morris Commercial C8 Quad
SKP Model 1:35 Scale Kit No. SKP 190
Page 2 of 4
backnextBody Assembly Images:
The fit of the interior floor to the body is good with quite positive attachment points.
You need to smooth out the ridge under the rear floor for the chassis to fit better.
The two large square fuel tanks help secure the floor and body sides in place when glued..

SKP
The body sheel and floor assembled.
Note the upper side windows were cut according the printed sheet but are too small
so you will need to measure these before cutting the windows from the clear sheet provided.
SKP
The engine compartment added to the body assembly.
You need to push the lower windscreen from inside the cab to mate better with the
sngine compartment otherwise there will be an excessive gap.
SKP
SKP
Chassis, front and rear suspension added to chassis, the drive shafts still to be added.
Nice positive locating points for the springs for easy assembly.

SKP
Drive shafts and central transfer box added, note there is no power driveshaft from the gearbox to the transfer box.
Note the transfer box had to be modified to allow room for the short front drive shadt to fit,
compare the transfer box shown here to the kit part to see the trimming from the front of the transfer box.

SKP
Front steering linkages, these are not movable after assembly.
SKP
Rear triangular mountings help to straighten out any minor twisting of the chassis in relation to the body.
You have to care with the orientation of the mountings which also need careful clean-up.
Note the undersurface air bubbles on the rear wall, these will disappear when painted
so don't need attention unlike some exposed air holes.
SKP
backnext



Back to Top